banner-line-matrix

Restore Printnet Factory Defaults

1) Power off the printer.

 

2) 10baseT           :Place switch 1 and 2 on the Printnet interface in the down position.

    10/100BaseT    :Place switch 1 on the Printnet interface in the down position.

 

3) Power on the printer.

 

4) Wait until the printer is "Online".

    10baseT           :Place switch 1 and 2 on the Printnet interface in the up position.

    10/100BaseT    :Place switch 1 on the Printnet interface in the up position.

 

5) Type in "arp -s ipaddress ethernetaddress" and press enter.
Example: arp -s 200.200.200.20 00-80-72-09-0a-03

 

6) Type in "telnet 200.200.200.20" and press enter.

 

7) Type in as username "root" and press 2 × enter.

 

8) Ignore the warning message.

 

9) Type in "store tcpip ifnum addr ipaddress" and press enter.
Example store tcpip 1 addr 200.200.200.20

 

10) Type in "store tcpip ifnum mask netmask" and press enter.
Example store tcpip 1 mask 255.255.255.0

 

11) When there is a router ( gateway ) in your Network type in the following "store tcpip route add default routeripaddress ifnum" and press enter.
Example store tcpip route add default 200.200.200.1 1

 

12) Type in "config http on" and press enter.

 

13) Type in "save" and press enter.

 

14) Type in "reset" and press enter.

 

15) Wait a two minutes.

 

16) Type in "telnet 200.200.200.20" and press enter.

 

17) Type in as username "root" and press 2 × enter.

 

18) If there still is a warning message. Do the following steps.

 

19) Type in "save" and press enter.

 

20) Type in "reset" and press enter.

 

21) Wait until the Printer displays Ehternet Ready. Then power down the printer.

 

22) Power on the printer while pressing the Online and Formfeed button, so it will come in download mode.

 

23) Type in ftp <IP ADDRESS> and press enter.
For example ftp 200.200.200.20

 

24) Type in root and press 2 × enter.

 

25) Type in cd dest and press enter.

 

26) Type in cd d1prn and press enter.

 

27) Type in bin and press enter.

 

28) Type in put <filename.prg> and press enter.